FlightOne Revolt V3

RaceFlight, Flight Controller
通常価格: 4,536  (税込)
4,374  (税込)
(税抜 4,050 )
FLO-FOR3
在庫あり
+

Revolt

The FlightOne Revolt flight controller is the most advanced, performance driven, flight controller ever designed. The Revolt uses a powerful F405 MPU, accompanied with the High Speed Invensense 20602 gyro, allows it to take full advantage of FlightOnes efficient code to run at 32KHz for the best Performance possible.

Performance

The Revolt presents not only the BEST performance, but also the most STABLE performance due to the amazing vibration rejection technology implemented in FlightOne. Our filters along with the integrated FlightOne Gummies, allow your quad to stay in the air no matter what! Damaged propellers caused by that insane gate clip on turn 3? Not a problem. You can still finish the race! Endless days of tuning are now a thing of the past. Our boards come preloaded with software and defaults that should fly amazing for 99% of people.

In addition to the vibration rejection technology, the SSG (Invensense 20602) gives you the highest speeds currently possible with the lowest noise floor and highest sensitivity. The Invensense 20602 gyro has never been used in any flight controller before (except the Revolt) and gives you the fastest response time possible as if the quad can read your mind.

Setup Simplicity

Setting up the Revolt is easy. The solder pin layout is easy to read with motor connections in each corner. Just solder the closest motors and the wizard handles the rest, you can put the Revolt in upside down and backwards just solder to the closest motor pad and the FlightOne wizards will handle the rest. The Revolt also features DFU (sometimes DFU mode is required to get the latest bootloader and use software that we don’t write) free updating and a self-healing and updating bootloader, just in case something does go wrong.

Features

  • LED Driver for WS2812b programmable LED
  • SBUS Inversion High Speed 32khz gyro, lowest noise floor and highest sensitivity gyro ever used
  • Through hole solder pads – forms an I-Beam when soldered for extra strength
  • FrSky Taranis, Spektrum, Futaba, JR, IBus, Sbus and other radio support
  • Integrated buzzer driver
  • Voltage and current ADC pins, for full voltage and current monitoring
  • Full telemetry output support
  • ESC flashing and configuration built into configurator
  • Most active software development
  • Selectable 3.3 voltage
  • 3 serial uarts
  • Bluetooth expandable
  • F4 processor 16mb of flash memory
  • GPS expandable
  • Pins into FlightOne Bolt 4in1 ESC
  • Dimensions: 36mm x 36mm
  • Mounting holes: 30.5mm squared to center of holes
  • Weight: 6 grams
  • Easily connectable to the FlightOne Bolt with our special connector.

The FlightOne Guarantee

Revolters will also get access to FlightOne’s ticketed tech support which will include step-by-step help with installation, tuning, and anything else that may arise with your Revolt.

Congratulations

You are now a FlightOne Revolter! Welcome to the exclusive club

FPV Accessory :
  • Flight Controller

投稿はありません

レビューを書く